Skyscraper City Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
23 Posts
Discussion Starter · #1 ·
I know there are some very talented designers on here (I marvel at the 3D renderings) :love: and I'm looking for someone who could put 2 lines of text into a dxf file so I can get some carpet waterjet cut for our building.

I can do it in Inkscape but it isn't exporting to dxf properly and although I've downloaded the trial version of AutoCAD, the learning curve is steeper than K2 (the mountain not the apartment building)

Any help gratefully appreciated:cheers:
 

·
Registered
Joined
·
23 Posts
Discussion Starter · #3 ·
Thanks -I'm sorted now. In case anyone stumbles across this having the same problem, the solution is to select all your text and convert them to paths before exporting the DXF file. Then it's all good! :banana:
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top